Hassle-Free Boiler Repair and Replacement in Wheeling

Here are some typical problems you might run into with hot water and steam boilers. While you may be able to fix a few of these issues without extra help, you may need a professional from Comfort Masters Service Experts for more complicated heat repair or a nasty boiler breakdown.

• Thermostat isn’t accurate. Check that it’s switched to “on” and the proper settings. Otherwise, your thermostat may need to be replaced.
• No heat. Broken parts, thermostat issues or insufficient water levels could be to blame.
• Leaking or dripping. Sometimes caused by a broken internal part, worn-out seal or corrosion.
• Banging, whistling or gurgling sounds. Air in the system, low water pressure or imminent part failure can create these noises.
• Rumbling or kettling noise. Restricted water flow due to lime and sludge accumulation in the heat exchanger. This causes water to overheat and boil.
• Pilot light is out. Caused by a worn-out thermocouple, draft or built-up deposit. Natural gas could also be turned off.
• Pressure is too low. Water could be leaking, or a pressure valve may need to be changed. Can also be caused by radiators that have been bled recently.
• Condensate pipe is frozen. This pipe runs outside, so there is a risk of freezing. Thaw it by pouring warm water over it.
• Radiators aren’t getting hot. Caused by sludge or air buildup in the system.
• Boiler keeps turning itself off. Could be caused by a number of issues: low water pressure, thermostat issue, closed valve causing low water flow, air or pump not circulating water properly.

Not scheduling routine service can often lead to boiler breakdowns. Comfort Masters Service Experts can help you choose a plan that could help you avoid costly service calls—and may increase your equipment’s efficiency.